Rev.1.2 – 7.2018.EL950.1.3.1086C
61
2. Insure there is no pressure on the coin return lever located on the changer itself. Slight pressure
will cause the changer to automatically reject coins.
3. Clean changer.
Q. Why won’t the unit take more than 3 - $1 bills, or more than 1 - $5 bill?
A. The VMC protects the amount of change in the changer and will only allow the bill acceptor to
take bills up to the highest vend price in the machine. For example, if your highest vend price is
$3, after inserting 3 - $1 bills or 1 - $5 you will not be able to insert more bills.
Q. In the event of a power outage, will I have to reprogram my prices, settings, etc.?
A. No, your settings are stored.
Q. Are the prices preprogrammed at the factory? Is there a default setting for all of the
programming functions?
A. Yes, the prices are pre-programmed at the factory to $1. However, programming the price settings
is a great way to get familiar with your machine while you are in test mode and prior to locating the
machine. Your first-hand knowledge will allow you a greater understanding of how the equipment
works.
Q. How often should I clean my payment systems?
A. This will depend on how much traffic you have at your machine – the more money inserted, the
dirtier the payment systems will become. Clean your payment systems on a monthly basis to begin
with. Lengthening the time between cleanings is at your own discretion.
Drink unit temperature and refrigeration:
Q. What type of environment is the equipment designed for?
A. The machine is specifically designed for indoor use only. Optimal location temperature is 75° F,
with 40% RH. Avoid placing unit in direct sunlight.
Q. How do I clean my condenser?
A. Remove the front bottom panel of the refrigeration unit. Brush the dirt and dust from the
condenser fins. You can also blow canned air (available at office supply/computer stores) on the
condenser or vacuum clean it. Do not damage the fins of the condenser while cleaning.
Reassemble the front bottom panel after cleaning.
Q. How do I set my temperatures, and what is the factory recommended low and high
settings?
A.
The unit is pre-set by the factory to the industry standard. See Set Point section of the
programming information to change the settings.
Q. My drink selections are not cold enough. How do I get them colder?
1. Make a small adjustment to the Set Point menu on the VMC. This should be done with extreme
caution!
2. Clean condenser coil (see Refrigeration section of this manual). The coil should be clean and lint
free, if dirt or lint build-up is on coil, this will restrict air flow and cause the compressor
temperature to rise above operating temperatures and compromise cooling.
3. Insure condenser fan and evaporator fans are running.
Note: this should be done with power cord unplugged from wall outlet for personal safety.
4. Insure you drink vendor is placed in a location that it is designed for, which is indoors only.
Installation in outside or environments without climate control will compromise cooling, potentially
damage your machine and void the warranty.
If further assistance is needed, please contact Seaga Customer Care or a local refrigeration technician.
Q. My drinks are not cooling at all.