Rev.1.2 – 7.2018.EL950.1.3.1086C
5
Once the machines have been unpacked and placed in their permanent location, the electrical connection
and mechanical connection must be made. Tools required: Adjustable wrench and Philips screwdriver. For
optimal installation, follow the order of connections as outlined below:
1. Mechanical Connection between Snack and Beverage Units:
The Snack and Beverage units must be screwed together for safety purposes. Two screws are
provided in the white envelope found in the vend area of the Snack unit. Square the fronts and
sides of the Snack and Beverage units. Open the Snack unit door and locate the two holes at the
bottom of the unit. Insert both screws and tighten.
2. Electrical Connection between Snack and Beverage Units and Beverage Display Lighting
Connection:
Cut an opening in the Styrofoam in the upper right (front) corner and save the foam for reinsertion.
Open the Beverage unit door and locate the beverage main harness and refrigeration harnesses.
See Figure 1. Insert harnesses through the opening up into the Snack cabinet, see Figure 2.
Figure 1 – Beverage and Refrigeration Harnesses Figure 2 – Inserting Beverage and
Refrigeration Harnesses
Connect the refrigeration harnesses to the two connectors found in the snack unit that are tied together,
see figure 2 above. (Note: the single harness located inside the snack unit is for the LED lighting which
is the next step).
Beverage and
Refrigeration
Harnesses
Refrigeration
Harnesses
Connected
Drop Sensor
(ELI2310)
Harness that
connects to
VMC
