Trouble Shooting
• When storing the SEASCOOTER
™
for extended periods
of time, open the Vent Plug in the Inner Nose Cone.
• DO NOT store battery in SEASCOOTER
™.
• ALWAYS store your SEASCOOTER
™
vertically when not
in use to prevent deformation of the Propeller Nozzle.
Unit does not function
If the motor does not start when both triggers are pressed,
make sure
1. The battery is properly connected
2. The battery is fully charged
(see page 13, charging the battery)
3. The master switch is in the "On" position
(see fig 2, page 6)
4. There is no water in the battery compartment
(see page 24, accidental flooding)
Blocked Propeller
If the Propeller becomes blocked first try and remove the
obstruction by removing the front grille. If this is not
possible the back grille and Propeller can be removed.
Under normal use the grilles must not be removed.
Removing the front grille to remove an obstruction.
1. Remove the SEASCOOTER
™
from the water.
2. Make sure the master switch is in the Off position.
3. Insert a screw driver as shown in figure 13 (page 21) to
remove the two grille pins.
4. Unclip grille as shown in figure 14 (page 21) .
5. Remove obstruction.
6. Reassemble grille and insert clips.
19
20
