Battery Use
Charging the battery
For battery charging follow these instructions.
1. Always ensure that the Master Switch is Off - see figure
2.
2. Always ensure that the SEA-DOO
®
SEASCOOTER
™
GTI is out of the water, dry and placed in a dry area.
3. Give a half turn to the Latches and remove them from
the Nose Cone as shown in figure 4.
4. Remove the Outer Nose Cone and Buoyancy Control
Chamber.
5. Open the Vent by unscrewing the Vent Plug.
6. Remove the Inner Nose Cone. To do this, first feed the
silicone ring (provided with this manual) through the latch
holes in the Inner Nose Cone and hook over the hooks
on the Battery Housing (see figure 6). Then screw the
Pump Nozzle onto the Vent Hole and pump air into the
Battery Chamber until the Inner Nose Cone pops off and
then remove the silicone ring.
7. Allow two minutes for any gasses to dissipate.
8. Disconnect the battery cable from the housing cable (if
not already disconnected - the cable will be
disconnected when you buy your SEASCOOTER
™
) by
pressing the locking feature, as shown in figure 7.
9. Remove the battery and place on a level surface.
10. Connect the battery cable to the charger cable.
11. Plug charger into mains, and turn on the supply.
12. Charging will take 6 to 8 hours for a fully discharged
battery. Flashing light indicates battery is fully charged.
13. Unplug the adapter from the mains.
14. Allow battery to stand for 30 minutes before using it.
15. Unplug the battery cable from the Charger cable.
16. When ready for use, install the battery and reconnect to
the housing cable.
14
13
Fig.6
Press here to release and pull to disconnect
Fig.7
