SD-MA-025
16
4.2.4
Custom Name - 2
On ‘Advanced Switch’ Page:
1.
Double click the column of ‘Custom name’
2.
Input the custom name
3.
Press ‘Enter’ to modify, or press ‘ESC’ to cancel.
4.3
Control via UART
4.3.1
Connect to device
The operation steps are as follows
：
1.
Connect PC and device with a straight serial port cable
2.
Run the PC control software (If already run, click to switch to the ‘Matrix Switch’ page)
3.
Click to switch ‘Ctrl Mode’ to ‘UART’
4.
Click the drop-down list whi
ch is right to the ‘Port’, then select the correct COM port (There may be
some COM ports connected to the PC)
5.
Click the ‘Disconnected’ button (which is right to ‘Status’) to connect to the device
6.
After connected successfully, the button right to ‘Status’ will be ‘Connected’ (
If you click it then, it will
disconnect from the device)
