Sea Tel ST94-21, Инструкция по установке и эксплуатации

Страница: 34 / 143

Installation ST94-21 C/Ku-Band TVRO
3-12
9. Apply Loctite to the bolt
threads and tighten all the
hardware to specified torque.
10. Remove the support blocks, or
jacks, and set the base frame
down on the flat, even,
assembly surface to align the
feet. Apply Loctite and
tighten all the hardware to
specified torque.
11. Install the Base Hatch and
clamp the latches from the
under-side.
3.8.3. Sub-assemble the bottom panels of the 144” Radome Assembly
Refer to the Radome Assembly drawing for your system and the procedure below. It is best to have at least
TWO people sub-assembling the radome, one working from the inside and the other outside. Sub-assemble
the sections of the radome on a clean, flat location that is free of rocks and debris (i.e. concrete) to assure
good horizontal alignment of the panels.
If there are a sufficient number of people available to each hold a panel while an additional person loosely
installs a bolt/nut high, mid and low on each flange, the bottom half of the radome can be assembled very
quickly. With three bolts loosely holding each flange the radome will then stand as a loose bowl and the extra
5 people can leave. Loosely install the rest of the hardware in each flange.
NOTE: Unless otherwise indicated, all nuts and bolts should be assembled
with Loctite 2760 or its equivalent.
If only 2 people are available,
12. On a flat surface, adjoin two
panels and loosely install a
bolt/nut high, mid and low in
the adjoined flange.
HINT: A crate, or other object, can be
put against the panels to hold them up
while additional panes are adjoined.
13. Continue adjoining additional
panels loosely installing a
bolt/nut high, mid and low on
each flange until all six panels
have been loosely assembled
to form the bottom half of
the radome.
14. Working as a team, loosely
install the rest of the
hardware in all of the flanges.
Do NOT tighten the bolts at
this time.
EAR Controlled - ECCN EAR99