Sea Ray Boats 52 Sedan Bridge, Руководство пользователя

Страница: 172 / 220

7.4
S
ECTION
7 • A
CCESSORIES
& O
PTIONS
52 Sedan Bridge (525 Sedan Bridge)
FULL
EMPTY
3/4
1/4
1/2
WATER LEVEL
B. W
ATER
T
ANK
The 52 DB has one (1) 140 gallon (530 liter) water
tank located between the port and starboard inboard
stringers in the bilge (Figure 7.5.1).
F
RESH
W
ATER
F
ILL
(F
IG
. 7.4.1)
W
A
TE
R
If a water treatment additive is not available, the
following steps may be followed to sanitize the water
system:
1. Pump the water tank empty. Shut OFF water
system breaker.
2. Determine the capacity of your water tank (your
standard water tank holds 150 gallons (567.75
liters)). You will need approximately one (1)
gallon of weak bleach solution for each fifteen
(15) gallons of tank capacity.
3. Prepare the proper amount of a weak bleach
solution by mixing 1/4 cup of unscented
household chlorine bleach per gallon of water.
4. Pour weak bleach solution into the water tank.
Remember, use about one (1) gallon of weak
bleach solution for each fifteen (15) gallons of
tank capacity.
5. Fill the remainder of the tank with fresh, clean
water. This will further dilute the weak bleach
solution.
6. Switch ON the water system breaker, then turn
on the faucets and allow the air to be exhausted
from the plumbing system. By doing this, the
entire fresh water system will be filled with a
sanitizing solution.
7. Allow the sanitizing solution to stand in the water
system for three (3) hours.
8. Pump the water tank empty.
9. Fill the water system completely with fresh,
clean water. Turn on the faucet and permit the
entire contents of fresh, clean water to run
through the system. This will flush the sanitizing
solution out of the plumbing.
10. Fill the water system again, with fresh, clean
water, and turn on the faucet to permit the air to
dissipate.
To check the water level in
the tank, press the water
level switch on the 12 volt
DC distribution panel located
in the aft salon. The lights will
indicate the amount of water
in the tank.
F
ILLING THE
W
ATER
T
ANK
The tank is filled through the fill plate located on the
port gunwale outboard of the transom. Fill the water
tanks only from a source known to provide safe,
pure drinking water. To fill your water tank you should
use a plastic hose. Do not use a rubber hose; it
can give the water a disagreeable flavor. The hose
should be kept for filling use only. After using the
hose it should be emptied. Start at one end and
raise the hose to shoulder level and walk to the
opposite end of the hose, allowing the remaining
water to flow out. You should store your water tank
filling hose in a clean dry place. It is also a good
practice to cover the ends of the hose to keep the
inside clean.
T
O
B
EGIN
I
NITIAL
O
PERATION
:
1. Fill the water tank with potable water.
2. Switch the water pump breaker to the ON
position.