Sea Pro 248, Руководство пользователя

Страница: 37 / 50

248 BAY SERIES 37
STORAGE
Storing your SEA PRO boat for an extended period of non
- use requires special preparations to prevent damage to
the boat and it ’ s systems.
The following information is for general guidelines only.
Always refer to the manufacturer Owner
’ s Manuals for
specific instructions and information pertaining to those
systems and components.
It is always a good idea to consult your SEA PRO BOATS
approved dealer or a certified marine technician before
performing Winterization and Storage procedures.
Fuel System: Fill the tank completely (100%) full with
fresh fuel and add a quality fuel stabilizer, following the
manufacturer
’ s instructions, to provide stability and
corrosion protection. This also prevents the formation
of varnish and
“ gumming ” of the lines and pump.
Engine: Replace the engine oil and filter. Flush the
engine with fresh water and let it completely drain.
“ Fog ” the engine with a corrosion - preventing fogging oil
according to the engine manufacturer ’ s
recommendations. Run fuel (ensure the fuel system has
been treated with fuel stabilizer) through the engine.
This ensures that all fuel lines and the engine contain
fuel that has a stabilizer mixed with it.
Lower Unit: Replace gear oil, checking for any moisture
which could show a sign of deteriorating seals.
Propeller: Remove the prop and apply a coating of grease
to the shaft and threads.
Grease Fittings: treat all fittings with the recommended
lubricant.
Fresh Water Washdown: If your SEA PRO boat has a fresh
water washdown system installed, turn on the pump,
open all connections and outlets, and drain all water
from the fresh water tank and lines. Run the pump until
the system is completely empty. Add a non
- toxic
antifreeze solution to the tank. Run the pump until the
antifreeze solution is running out of all connections
and outlets.
Raw Water Washdown: Open the seacock that supplies
water to the raw water washdown pump allowing all
water to drain from the system. Open the cap at the
outlet connection. Run the raw water washdown pump
for a short time to drain any residual water in the pump
and lines. Remove the inline strainer and empty any
water in the strainer and lines.
Livewell Pumps & Seacocks: Open all seacocks, allowing
all water to drain from the pumps and lines.
Drains, Manifold and Bilge Plug: Open the drain plug and
check that all debris has been cleaned and removed from
around all drains, the single port manifold, and the
bilge drain plug. This ensures that any moisture that
enters the boat can drain properly.
Batteries: Remove the batteries and perform the
necessary maintenance as outlined in the Manufacturer
Owner
’ s manual. Store the batteries out of the boat and
in a safe location. Clean the cable terminals and apply a
coat of battery cable grease.