10
11
Fig.6
Press here to release and pull to disconnect
Fig.7
Charging the battery
For battery charging follow these instructions.
1. Always ensure that the Master Switch is Off - see fig. 2.
2. Always ensure that the SEA-DOO
®
SEASCOOTER
™
VS Supercharged is out of the water and placed in a dry
area.
3. Give a half turn to the Latches and remove them from
the Nose Cone as shown in fig. 4.
4. Remove the Outer Nose Cone and Buoyancy Control
Chamber.
5. Open the Vent by unscrewing the Vent Plug.
6. Remove the Inner Nose Cone. To do this, first feed the
silicone ring (provided with this manual) through the
latch holes in the Inner Nose Cone and hook over the
hooks on the Battery Housing (see fig. 6). Then screw the
Pump Nozzle onto the Vent Hole and pump air into the
Battery Chamber until the Inner Nose Cone pops off and
then remove the silicone ring.
7. Allow two minutes for any gasses to dissipate.
8. Disconnect the battery cable from the housing cable (if
not already disconnected - the cable will be disconnected
when you buy your SEASCOOTER
™
) by pressing the
locking feature, as shown in fig. 7.
9. Connect the battery cable to the charger cable.
10. Plug charger into mains, and turn on the supply. Do
not replace the Nose Cone.
11. Charging will take 4 to 6 hours for a fully discharged
battery. When the battery is charging the LED charger
remains on, when the battery is charged the LED
flashes.
12. Unplug the adapter from the mains.
