Trouble Shooting
Fig.14
18
19
Fig.13
1
2
Unit does not function
If the motor does not start when both triggers are pressed,
make sure:
1. The battery is properly connected
2. The battery is fully charged (see page 10, charging the
battery)
3. The master switch is in the "On" position (see fig 2,
page 6)
4. There is no water in the battery compartment (see page
22, accidental flooding)
Blocked Propeller
If the Propeller becomes blocked first try and remove the
obstruction by removing the front grille. If this is not
possible the back grille and Propeller can be removed.
Under normal use the grilles must not be removed.
Removing the front grille to remove an obstruction.
1. Remove the SEASCOOTER
™
from the water.
2. Make sure the master switch is in the Off position.
3. Insert a screw driver as shown in fig. 13 to remove the
two grille pins.
4. Unclip grille as shown in fig. 14.
5. Remove obstruction.
6. Reassemble grille and insert clips.
Removing rear grille and Propeller to remove obstruction
1. Remove the SEASCOOTER
™
from the water.
2. Make sure the master switch is off.
3. Remove the battery.
4. Unscrew the six rear grille screws as shown in fig. 15.
