Sea-doo 4-TEC series 2008, Руководство по ремонту

Страница: 30 / 555

ssi2006-013-011_a
Lubricate the throttle body to prevent corrosion
on external and internal parts especially if
the craft is used in salt water.
Remove the throttle body lubrication fitting cap.
Open the throttle body valve by pressing slightly
the throttle lever and spray BOMBARDIER
LUBE lubricant (P/N 293 600 016) through the
fitting to lubricate valve mechanism.
Spray generously the external parts
of throttle body.
Close the throttle body lubrication fitting cap.
INTERCOOLER AND
EXHAUST MANIFOLD
ANTIFREEZE PROTECTION
The intercooler and manifold are not self draining;
they need the following protection.
With the vehicle leveled, remove both
intercooler hoses [1] and [2].
1
R1503motr361A
2
Let the intercooler drain and at the same time
position the bottom hose as low as possible into
the bilge to drain as much water from the exhaust
manifold, then reconnect the bottom hose.
Connect an extra piece of hose to the upper
intercooler nipple and pour approximately 200 mL
(6.76 oz U.S.) of antifreeze into the intercooler.
Then pour approximately 300 mL (10.14 oz
U.S.) of antifreeze into the upper Intercooler
hose, toward the exhaust manifold.
Reconnect the intercooler upper hose.
CAUTION: Failure to pour antifreeze into the
intercooler and exhaust manifold, may cause
severe damage to these components.
CAUTION: Use only undiluted antifreeze (100%
concentration). The premixed antifreeze
available from BRP is NOT suitable for this
particular application. Its concentration will
be reduced when mixed with remaining
water trapped in water jackets.
NOTE: Antifreeze must be compatible with
internal combustion aluminum engines. It is
recommended to use biodegradable antifreeze.
This will contribute to protect the environment.
Recreational vehicle (RV) antifreeze can be used.
NOTE: The engine will not have to run during
this operation but should have been ran before,
to exhaust as much water as possible, from
cooling system components.
BATTERY
Remove
Clean
Charge
Store
Refer to CHARGING SYSTEM in SHOP MANUAL .
WATERCRAFT CLEANING
Clean the bilge with hot water and mild detergent
or with bilge cleaner. Rinse thoroughly. Lift front
end of watercraft to completely drain bilge. If
any repairs are needed to body or to the hull,
touch up paint and Gelcote
†† repair kits are
available. Replace damaged labels/decals.
Wash the body with soap and water solution
(use mild detergent only). Rinse thoroughly
with fresh water. Remove marine organisms
from the hull. Apply a nonabrasive wax.
†† Gelcote is a registered trademark of Gelcote International.
Service 2006-15 3 /
4
www.SeaDooManuals.net