Sea-doo 4-TEC series 2008, Руководство по ремонту

Страница: 28 / 555

Date:
September 14 2006
Subject:
Storage Procedure for 4-TEC™
Engine Equipped Vehicles
No.
2006-15
MODEL YEAR MODEL MODEL NUMBER SERIAL NUMBER
2006 All 4–TEC engine equipped vehicles All All
NOTE: Refer to appropriate Sea-Doo SHOP
MANUAL when servicing a Sea-Doo watercraft.
NOTE: Intercooler equipped models
require extra maintenance. Refer to
INTERCOOLER ANTIFREEZING PROTECTION
section of this bulletin.
PROPULSION SYSTEM
Verify jet pump grease for water contamination.
Check for the presence of water in cone and
bearing; if so, replace oil seal and sleeve. Refer
to
SHOP MANUAL for proper procedure.
CAUTION: Use only Bombardier* jet pump
grease or equivalent, otherwise components
service life could be reduced. Do not mix
grease brands or types.
FUEL SYSTEM
Verify fuel system.
Check fuel hoses for leaks.
Replace damaged hoses or clamps if necessary.
Fill up fuel tank completely. Ensure there
is no water inside fuel tank.
NOTE: Sea-Doo Fuel Stabilizer (P/N 413 408 600)
or equivalent should be added in fuel tank to
prevent fuel deterioration. Follow manufacturer’s
instructions for proper use.
CAUTION: Should any water be trapped inside
fuel tank, severe internal damage will occur to
the fuel injection system (if so equipped).
CAUTION: Fuel stabilizer should be added
prior to engine lubrication to ensure fuel
system components protection against
varnish deposits.

WARNING
Fuel is inflammable and explosive under
certain conditions. Always work in a well
ventilated area. Do not smoke or allow open
flames or sparks in the vicinity. Fuel tank
may be pressurized, turn cap slowly when
opening. Never use an open flame to check
fuel level. When fueling, keep watercraft level.
Do not overfill or top off the fuel tank and
leave watercraft in the sun. As temperature
increases, fuel expands and might overflow.
Always wipe off any fuel spillage from the
watercraft. Periodically inspect fuel system.
Always turn the fuel tank valve
(if so equipped)
to OFF position when storing the watercraft.
ENGINE OIL AND FILTER
CHANGE
Change engine oil and filter.
Refer to LUBRICATION in ENGINE section
of
SHOP MANUAL .
EXHAUST COOLING
SYSTEM FLUSHING
Flush exhaust cooling system with fresh
water to prevent salt, sand or dirt accumulation
which will clog water passages.
For proper procedure, refer to FLUSHING AND
LUBRICATION in
SHOP MANUAL .
CLOSE LOOP COOLING
SYSTEM (ENGINE)
Replaced antifreeze for the storage period to
prevent antifreeze deterioration.
Printed in Canada. (sbs2006-005 PM)
1 /
4
©2006 Bombardier Recreational Products Inc. and BRP US Inc. All rights reserved.
®™ and the BRP logo are trademarks of Bombardier Recreational Products Inc. or its affiliates.
www.SeaDooManuals.net