Sea-doo 4-TEC series 2008, Руководство по ремонту, Страница: 33 / 555

Intercooler Protection
255 Models (X Packages)
It is important to expel any trapped water that may
have accumulated from condensation in the exter-
nal intercooler.
Proceed as follows:
1. Removed the intake hose from the throttle
body.
sbs2008-005-001_a
1. Intake hose (from intercooler)
2. Throttle body
2. Start and rev up the engine to 4000 RPMs sev-
eral times.
sbs2008-005-002
WATER EXPELLED FROM INTERCOOLER
3. Stop engine.
4. Liberally lubricate throttle body inside and out.
5. Clean off any lubrication on the throttle body
intake hose flange.
6. Install air intake hose to the throttle body.
Engine Lubrication
Refer to
ENGINE LUBRICATION
in
STORAGE
PROCEDURE
section in 2008
SHOP MANUAL
.
Exhaust System Protection
In areas where temperature may freeze, water
trapped in the exhaust system must be removed.
Refer to STORAGE PROCEDURE in the 2008
SHOP MANUAL
Engine Coolant Test
NOTE:
Antifreeze replacement should be per-
formed every 2 years.
Perform an antifreeze density test.
NOTICE Improper antifreeze density in cold
areas may lead to serious engine damage.
Battery
Remove, clean, charge and store.
Refer to CHARGING SYSTEM in
SHOP MANUAL
.
NOTE:
Poor maintenance and improper charging
methods contribute to the majority of battery
failures. Over 60% of battery claims are filed
after the storage season.
BRP will not consider
claims for batteries following a storage sea-
son.
Watercraft Cleaning and
Protection
Refer to STORAGE PROCEDURE in the 2008
SHOP MANUAL
2 / 2 2008-10 SERVICE
www.SeaDooManuals.net