7
6
1100mm
485mm
720mm
Ø200
340mm
830mm
material
Heating Capacity
Kw output
avg emissions
Avg Efficiency
glass door
minimum flue Height
flue dimensions
outside air Kit
warranty
weight
minimum Hearth dimensions
oVerall Zero ClearanCe boX dimensions
FRONT
SIDE
aXiS i1000iB double Sided
*Heating capacity of the following appliances are a guide only and refers to areas with 2.4m ceilings
and 6 or more star rated buildings. Heating output may vary depending on factors such as building
characteristics, quality of insulation, type of firewood used and climate zone.
**See warranty pg. 29 of the manual.
***refer to pg. 8 for further details about the clearances & hearth.
2. SpecificationS
Solid steel firebox with firebricks
Up to 15-30 Squares
*
18.7kW
1.0g/kg
62%
2x Secure Swing door opening system
4.6m
200mm, 250mm, 300mm
recommended for well insulated homes
10 year firebrick & 5 year firebox warranty
**
180kg
Width: 1300mm Depth: 550mm (either side of firebox - 1605mm total)
thickness: 42mm
***
2. SpecificationS
this appliance and flue were tested with the following minimum clearances.
the axis i1000iB and Z/c box was tested in a combustible enclosure in a manner conforming to aS/nZS
2918:2001, appendix B. the sides and rear of the wall enclosure must be no closer than
50mm
from the
sides and rear of the appliance zero clearance box. The front wall of the enclosure must be made of a
non-combustible material to a height of
300mm
above the appliance fascia and must extend to
100mm
either side of the appliance fascia. the internal wall studs of the appliance must also be made of a non-
combustible material.
important: mantel sHelf:
mantel shelf and mantel upright clearance was not tested and should
be installed as per clause 3.4.1.3 (b) of AS/NZS 2918:2018.
a minimum
520mm
deep X
1100mm
wide and
25mm
thick floor protector (Skamotec board or similar)
should be used under the appliance. the floor protector/hearth should also extend a minimum
1220mm
wide X
700mm
deep X
25mm
thick (Skamotec board or similar) and must be used in front of the
appliance (see joint AS/NZS 2918:2018 3.3.2).The floor protector must extend
700mm
in front of the
fuel loading door and be placed centrally in the
1220mm
width.
The appliance is required to be installed on 30mm high spacers inside the zero clearance box between
the appliance and the base of the zero clearance box.
please note
:
a minimum 50mm air gap must be maintained around the outer triple skin flue in the
ceiling of the enclosure.
clearances & Hearth- axis i1000iB SinGle Sided
siDE
Front
toP
*all diagrams are not to scale
50MM air gaP
Min 1220MM
520MM
700MM
50MM air gaP
300MM
non-CoMBustiBlE
non-CoMBustiBlE
stuD
non-CoMBustiBlE
MatErial
non-CoMBustiBlE
MatErial
50MM air gaP
25MM
Floor ProtECtor
(Must BE a Fully
suPPortED BasE)
Min 100MM
MiniMuM
50MM
air gaP FroM
CoMBustaBlEs
Min 100MM
TOP
Dimensions of the firebox: 994mm Width; 589.5mm Height; 506.5mm Depth
