5
SECTION 2: GETTING STARTED
2.1 POWERING ON THE LIVEWIRE TS+
There two ways to power on the device. If you would like to flash your vehicle, you will
need to use the vehicle instructions below. If you are looking to update or load custom
tunes onto your device you will use the Computer instructions below.
USING THE VEHICLE
1. Locate the vehicle’s OBD II port. This port is usually located under the vehicles dash
board on the driver’s side. The port may be covered with a cap or compartment door
labeled OBD II port.
2. If the connector pins are covered or the port is located behind a compartment door,
remove the cap or open the compartment door.
3. Connect the OBD connector from the Livewire TS+ to the vehicles OBD II port.
USING THE COMPUTER
1. Install SCT Device Updater
www.sctflash.com/
support
before
connecting your unit via USB
(Updater Download)
2. Locate the computer’s USB port. This port can
usually be found on the front or the back of
the computer, if using a laptop the ports will
usually be on either side of the laptop.
3. Using the USB cable provided connect the USB end of the cable to the PC and the right
side of the Livewire TS+.
