Scott 10,000, Инструкция по эксплуатации

Страница: 56 / 323

3 Operation
3--16
C9999--2 Issue 1
MOUNTING SCREW
IN FEED ROLLER
FEED WINDOW
Fig. 3-30. Adjust Feed Roller Tension
3.3.2.4 In--Feed Roller Tension Adjustment
The In--Feed Rollers are used to assist sheets into
the Heat Rollers.
To Adjust the In--Feed Rollers
Step: 1. Loosen the In--Feed roller shaft mounting
screw.
Step: 2. Use your fingers to apply downward
pressure to the spring plates and tighten
the mounting screws.
PAPER STOCK
STATIONARY
PAPER
GUIDES
ADJUSTABLE
PAPER
GUIDES
MIDDLE
FRONT
GUIDE
Fig. 3-31. Paper Side and Back Guides
3.3.2.5 Paper Side and Back Guides
The right hand guide remains in the same position
for all sheet sizes. The left hand guide must be
adjusted for sheet size. Allow approximately 1/16”
(1.5mm) freedom in the stack. The back guides
should be adjusted close to the stack.
3.3.2.6 Compensating for a Tilted Stack of Paper
Uneven paper stacks can be compensated for by inserting strips of binder’s board every so often on the low
side of the stack. It is recommended to use a piece of binder’s board the same size as the sheet as a
platform for the stack. Make sure it is heavy enough not to be picked up by the nozzles.
3.3.2.7 Curled Stock
The nozzles will compensate for quite a bit of curl in the paper. However, if the curl is too bad, it may be
necessary to roll the stock by hand before loading it into the pile feeder.