Scott Safety X190, Руководство по эксплуатации и инструкция

Страница: 21 / 26

21
6.0 Additional Information
6.1 Cleaning And Maintenance Information
Following use, the X190 should always be cleaned and inspected for damage. In the event of damage being detected
(for example, cracked or broken window or housing), the thermal imager should be withdrawn from service immediately
and returned to an authorized service center for repair.
CAUTION
Regularly inspect the X190 thermal imaging camera and charging system for loose, worn, or damaged
components. If any damage is found, remove the unit from service and tag for repair by authorized
personnel.
WARNING
EXPOSURE TO SOME CHEMICALS MAY DEGRADE THE SEALING PROPERTIES OF MATERIALS USED IN THE X190
THERMAL IMAGING CAMERA. ONLY USE WARM SOAPY WATER AND NONABRASIVE CLEANERS.
•
Inspect all lenses for soot / dirt buildup. Clean if necessary.
•
Normal “normal use” scratches on the high efficiency aspheric lens do not degrade picture quality;
however chips may affect transmission quality. Inspect IR lenses for chips.
•
Inspect the unit for structural, heat, and/or chemical damage.
•
Inspect all battery contacts for corrosion or damage.
•
Inspect battery charger.
•
Inspect all batteries and battery adapters for damage or leakage.
•
Check all switches including the battery charger for proper indication that systems are running correctly.
•
Inspect battery charger contact points for corrosion or damage.
•
Always check the battery charger to ensure proper operation.
•
Inspect all surfaces for heat or chemical damage, cracks and breaks.
•
Inspect the mechanical hardware to make sure no screws have loosened or are missing.
•
Store your X190 in its optional truck mounted charger, or in the optional delivery case if ordered.
•
The thermal imager should be cleaned using warm soapy water and nonabrasive cleaners. Allow the
thermal imager to completely dry before replacing in its carrying case. Note: Do not use solvents and
abrasive cleaners.
•
It is recommended that the display is treated with anti-fog solutions as used on SCBA facemasks.
Scott Safety recommends Klean n’ Klear Anti-Fog Cleaner (P/N 60158).
•
To ensure long service life, it is recommended that the thermal imager and its accessories are stored in
temperate environment (58
o
F - 95
o
F, moderate humidity) at all times.
•
The batteries should always be removed from the thermal imager before storage for extended periods.