Oscillator
(front display side)
Fig. 6
Fig. 7
Fig. 8
Stabilizer Flange
5"
5"
5"
3/8" x 2" SS Bolt /Nut
0°- 359°
Sweep
Yoke Assembly
5. Slide the Stablizer Flange up
onto both Oscillator poles,
with the larger copper bushing
facing downward on the front
rotating pole. Do not tighten at
this time. Fig. 6
6. Slide the yoke assembly over
the bottom of the rotating pole
with stainless steel debris shield
facing towards front display.
Secure with the bolt and nut
provided. Fig. 7
7. Secure the Stablizer Flange 5”
from the upper edge of the yoke
with the supplied hex wrench.
Fig. 8
4
Oscillator Assembly and Installation
(Dock Mount Aquasweep Only)
Weathproof control unit
allows for start and stop
positioning from 0-359°.
Our fully programmable oscillator
attachment makes moving muck even
easier. No need to turn the AquaSweep in
its mounting; the oscillator does it for you!
We pre-program the oscillator to rotate
the AquaSweep in 20 degree increments
every 20 minutes; you set it for any radius
you wish. The oscillator attachment can be
added to any new or previously installed
dock-mounted Aquasweep.
For assembly with a new
Aquasweep, follow steps 1-4 for
yoke assembly and dock mounting
bracket installation on page 3.
If addding to an installed
Aquasweep, begin by removing
bolt that secures the stainless
steel pole to the yoke assembly.
The oscillator replaces the
stainless steel pole on your dock
mount Aquasweep.
See back for setting the
Aquasweep controls
Extension cords must not be
used. Always disconnect power
when swimmers are present.
!
