Fig. 4
Yoke Assembly
12"
Dock
Mounting
Stainless
Steel
Pole
Plate
Fig. 3
Thumb
Screws
Fig. 5
3/8" x 2" SS Bolt /Nut
Aquasweep
Housing
Angle Adjustment
SS Debris Shield
Fig. 2
Fig. 1
3
Dock Mount Assembly and Installation
For repositionable installation
along longer docks, consider
fastening dock mounting
bracket to a 2" x 10" x 24"
board and securing to dock
with sturdy C-clamps.
(optional) Dock Post
Mounting Bracket
Fits posts up to 2-1/2" Dia.
Part #16501
Accommodates Larger
U-clamp rings up to 4" Dia.
Determine location that will best
position the Aquasweep to clear
debris, in a minimum water depth
of 12". Adjust depth 4" from lake
bottom. See back page for additional
guidelines.
Check that the dock framing is sturdy
and will accept mounting bracket
screws. Housing angle and direction
can be adjusted as needed to clear
muck and debris a full 360° area.
1. Begin the assembly of your
AquaSweep dock mount model by
removing the stainless-steel bolt
from the yoke assembly. Adjust
the AquaSweep housing 90° to the
yoke and tighten bolt. Fig. 1
2. Next, align the 3 holes on the
stainless steel debris shield with the
3 pre-drilled holes on the housing
and fasten with the 3 small self-
tapping screws provided. Fig. 2
3. Secure the dock mounting bracket
to your wooden or metal dock,
utilizing the 4 phillips head screws.
If necessary, drill pilot holes to
prevent cracking of deck material.
Fig. 3
4. Once the dock mounting bracket
has been secured, the stainless-
steel pole can be inserted thru the
dock mounting bracket. Simply
loosen the 2 thumb screws from
the dock plate sleeve, insert the
pole from the top thru the sleeve by
approximately 12 inches, and then
retighten the 2 thumb screws. Fig. 4
Oscillator Fig. 6
Adjust for varying water levels by
loosening the 2 thumb screws from
the dock mounting bracket and
raising or lowering the AquaSweep.
Please note, the 2 thumb screws
are coated with a special lubricating
compound specifically designed
for stainless-steel to ensure proper
function. An extra packet of this
compound has been included
with your AquaSweep purchase;
periodic lubrication of the 2 thumb
screws is required for years of
problem free use and for warranty
validation.
For oscillator installation, continue
on page 4
5. Now, slide the yoke assembly
over the bottom of the stainless-
steel pole and secure with the bolt
provided. Fig. 5
6. Finally, power can be supplied
to your AquaSweep utilizing a
standard 110 or 230 volt receptacle
protected by a GFCI.
Extension cords must not be
used. Always disconnect power
when swimmers are present.
!
