REMOVAL & REPLACEMENT
To Replace Vend Switch:
1. Disconnect Electrical Power.
2. Pull out and remove upper front panel.
Lever Type
A. Twist ice chute 1/3 turn and pull down to
remove.
B. Remove screws holding mounting plate to
cabinet. Pull plate assembly out and away from
cabinet. Switch is mounted to valve plate.
Push Button
A. Locate vend switch behind push button.
B. Remove wires from switch.
C. Remove screw & nut retaining switch to
mounting plate, and remove switch from dispenser.
3. Reverse steps to reassemble.
To Replace Gear Motor Assembly:
1. Disconnect electrical power.
2. Remove cover from hopper.
3. Unscrew sweep arm holding rotor to gearmotor
shaft.
4. Remove rotor from gearmotor shaft.
5. Remove splash panel
6. Twist ice chute 1/3 turn and pull down to remove.
7. Remove ice chute mounting plate.
8. Remove screws holding valve mounting plate to
cabinet. Pull valve assembly out and away from
cabinet.
9. Mark location of gearmotor bracket on cabinet.
10. Disconnect gearmotor electrical leads in
control box.
11. Remove (4) screws holding gearmotor to
bracket..
12. Remove (4) screws holding bracket to cabinet.
13. Pull gearmotor bracket from cabinet.
14. Dismount gearmotor from dispenser.
15. Reverse to reassemble. Gearmotor bracket
should be installed where it was, so that the rotor
should clear bin surface by 1/8" to 1/4". If needed,
the slots on the gearmotor bracket will allow the
position of the rotor to be adjusted.
To Replace Solenoid:
1. Disconnect electrical power.
2. Pull out and remove upper front panel. Remove
fluorescent tube light if used.
3. Remove 2 thumb screws holding lower brace
and remove.
4. Remove 3 thumb screws holding upper ice
chute cover, and remove cover.
5. Disconnect electrical leads from solenoid.
6. Straighten cotter pin, and remove pin from
solenoid plunger.
7. Remove rubber mounting screws holding
solenoid to cabinet, and remove solenoid from
cabinet.
8. Reverse to reassemble.
To Replace Light: (Optional)
1. Disconnect electrical power.
2. Pull out and remove upper front panel.
3. Twist fluorescent tube out of sockets.
4. Reverse to reassemble.
Electrical Shock
Hazard.
Unplug unit before
servicing.
LIGHT TUBE
IS160 and IS220
August 1995
Page 12
