IRD-2600 / IRD-2800
Integrated Receiver Decoders
P/N 2349-72784-00
Page 2-11
For DSNG Front/End Receiver to the IRD-2600 / IRD-2800, proceed with Table 2-7.
For QPSK Front/End Receiver to the IRD-2600 / IRD-2800, proceed with Table 2-8.
For QAM Front/End Receiver to the IRD-2600 / IRD-2800, proceed with Table 2-9.
Refer to chapter 3: Operation for instructions on all other input types as well as for Decoder
Only operation, configuration and/or changing the device Product Type.
Table 2-7:
DSNG Receiver Configuration Procedure
SEQ.
#
PARAMETER SET
PROCEDURE INSTRUCTIONS
a.
RECEIVER CONFIGURATION
Function Start.
The
CONFIG
sub menu is displayed.
Select the
RECEIVER
option and proceed to configure as
described below.
b.
Frequency Range
Parameter
1.
Select
Frequency Range
option.
2.
Set the frequency according to the BAND input.
c.
LNB Power Supply
Parameter
3.
Select
LNB Power Supply
option.
4.
Set the LNB Power Supply to: 14, 18 or OFF as
required
d.
LNB 22 kHz
Parameter
5.
Select
LNB 22 kHz
option.
6.
Using the controls, set the option to ON or OFF as
required
e.
Input Signal Source
Parameter
7.
Select
Input Signal Source
option.
8.
Set to A input.
f.
Symbol Rate
Parameter
9.
Select
Symbol Rate
option.
10. Set the Symbol Rate as required.
g.
Modulation Mode
Parameter
11. Select
Modulation Rate
option.
12. Set to AUTOMATIC.
h.
Nyquist Filter Roll-Off
Parameter
13. Select
Nyquist Filter Roll-Off
option.
14. Set to AUTOMATIC.
i.
Viterbi Rate
Parameter
15. Select
Viterbi Rate
option.
16. Set to: 1/2, 2/3, 3/4, 4/5, 5/6, 6/7, 7/8, 8/9, or
AUTOMATIC as required.
j.
Spectral Inversion
Parameter
17. Select
Spectral Inversion
option.
18. Set the option to AUTOMATIC, NORMAL, or
INVERTED as required.
