scope DataPage MK2, Руководство пользователя и инструкция по установке

Страница: 7 / 21

DataPage MK2 (USA) Desktop UHF Radio Paging System
DPUSA 02/00
7
Issue 2
4) Plug the AC adaptor into a convenient wall socket. When the unit is first powered up the system will display
the following screen for a few seconds:
SCOPE MARKETING Followed by: ENTER PAGER No:
DataPage Vx.xx
>
The flashing cursor invites you to enter a pager number (this can be any number between 1 and 9,999) after
which you must press ENTER for the number to be accepted. Pressing the CANCEL key at this stage will return
the user to the pager number prompt to begin again. Pressing the SEND key in place of the ENTER key will
transmit a tone only message to the pager using the default beep type .
5) After pressing ENTER, the next screen appears to offer the selection of the beep types. Again, the flashing
cursor invites you to enter a selection.
At this point the operator may choose to select a beep type 1,2,3 or 4,
or press ENTER without making a selection. This will attach the default
beep type to the call. (It should be noted that not all pager types
currently carry the transmitter selectable beep type). In the event that BEEP TYPE (1-4):
your pagers are so equipped, selecting 1,2,3 and 4 will correspond to >
beep types A, B, C and D respectively. Pressing the SEND key at this
stage will send a tone only message together with the beep type selected.
6) After selecting the beep type, press ENTER. The screen will now prompt
ENTER MESSAGE:
for you to enter a message of up to 20 digits, including [, ] and spaces. >
Note: the screen will scroll after entering 15 digits.
7) After selecting the message, press ENTER or SEND. The call will now
be transmitted to the pager. A confirmation message will briefly appear Sending Message
on the screen. Please Wait
Pressing the ‘CANCEL’ key at any stage of operation and any entry level will immediately revert the unit to the
‘ENTER PAGER No:’ prompt.
Dry Contacts
There are two volt-free (dry) contacts available for use with either Normally Open, Normally Closed or Change of
State switches (see
Program Parameters, section 2: Inputs ). When either is triggered, the programmed
message(s) will be sent to the selected pager (or group of pagers). When used in the Normally Open mode
only, the message will repeat whilst in the active state (can be used as a safety mode).
Connection is via 3.5mm locking jack plugs at the rear of the unit (see fig. 2).