scooterxtras
.com.au
ASSEMBLY
- CANOPY ON SCOOTER
The pre-assembled canopy with upper windscreen
and rear frame fitted can now be fitted onto
the mobility scooter.
(refer to sequence stated and shown below):
IMPORTANT NOTE:
2 people are required to fit the
pre-assembled canopy to the scooter.
1. Turn the pre-assembled canopy over
and offer up to the scooter,
2. Line up the frame on the upper
windscreen with the lower
windscreen frame,
3. Line up the rear frame with the
bag carrier frame,
4. At the same time - locate the canopy
onto the various mounting frames,
5. Flex the windscreens to clear the cross
tube during location onto lower
windscreen.
If required:
Using a rubber mallet - lightly tap
the Upper Windscreen / Rear Frame
down until fully located.
9.
