Page 6
5.
Use a #2 phillips screwdriver to remove the top
and bottom chain guard screws and washers,
then use this hardware to install the RPM sensor.
6. Peel
off the adhesive backing and stick the
magnet mount to the fl ywheel, ensure that the
curve at the base of the mount sits against the
axle hub.
NOTE:
Pieces of the frame and chainguard have been
removed for clarity.
7.
Place the magnet inside the magnet mount at
the third, farthest hole from the fl ywheel axle.
8. Turn
fl ywheel to verify the light on the sensor
lights up.
