Schwamborn 795350, Перевод оригинального руководства по эксплуатации

Страница: 18 / 48

5 Acceptance and transportation
EN Floor milling machine BEF 204
18
Due to wear, the milling discs [15] and the
spacers[16] are reduced in diameter and get
narrower.
Danger of imbalance!
Each multi‐disc rod has to be equipped with the
same number of milling discs and spacers.
All milling discs should move easily.
The movement of the milling discs wears down
the multi‐disc rods and wear tracks develop.
The manufacturer recommends also renewing
all the multi‐disc rods whenever the milling discs
are replaced.
Risk of damage due to worn multi‐disc rods!
Multi‐disc rods that are excessively worn can
break and cause significant damages.
2. Install new multi‐disc rods if necessary.
4.4 Checking electrical components
Only suitably knowledgeable, qualified profes­
sional electricians may perform work on any
electrical parts of the machine!
Risk of fire due to faulty electrical cables! Check
the mains cable and power plug regularly for
functional safety.
4.5 Customer service and spare parts
Only manufacturer’s original replacement parts
may be used.
In case of customer service queries, replacement
parts or repairs, please contact the manufacturer. To
ensure your queries are dealt with as quickly as pos­
sible, always quote your machine data (type, fea­
tures).
5 Acceptance and transportation
Observe the safety instructions in Chapter 2.
5.1 Machine acceptance
The machine is supplied in a complete and packaged
condition from the manufacturer.
1.
Unpack machine and check the enclosed
delivery slip to make sure all parts are delivered.
2. Check for any transportation damage.
In case of damage, contact the transport com­
pany promptly.
Report any problems to the manufacturer imme­
diately.
Complaints at a later date cannot be acknowled­
ged!
5.2 Transporting the machine
Proceed with the greatest care and caution!
Observe weight data on packaging or in the ac­
companying documentation.
Never walk or reach beneath the load while it is
being lowered.
Wear safety shoes! Wear safety gloves!
Devices for lashing and transporting the unit
have to be rated to handle its full weight and
dimensions.
When transporting with a crane or similar device
no additional loads may be lifted together with
the machine.
Risk of injury from heavy loads!
Suspended loads can fall or tip over, causing
serious injuries!
Do not stand under suspended loads!
Raising and lowering the load must be per­
formed by two persons!
Do not raise loads any higher than necessary!
Prevent the load from swinging back and forth!
Keep sufficient safety distance.