Schwaiger LWH 031, Инструкция по эксплуатации, Страница: 9 / 16

9
Tools Required
Phillips Head Screw driver
Stud finder for drywall installation
Electric drill and 1/4” (8mm) masonry bit for concrete/brick installation
Note: You need to insert the bubble level system when you install the wall plate and take it
away fate you finish installation.
WARNING
• Do not begin the installation until you have read and understood the instructions and warnings
contained in this installation sheet. If you have any question regarding any of the instructions or
warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as specified in this manual.
Improper installation of this product may cause damage or serious injury.
• This product should only be installed by someone with good mechanical ability who has basic
building experience and fully understands this manual.
• Make sure that the supporting surface will safely support the combined weight of the equipment
and all attached hardware and components.
• Always use an assistant or mechanical lifting equipment to safely lift and position the equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage to the items, This
greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could lead to product
failure and personal injury.
Safety Notes
If you have doubts about a safe installation, have it installed by a qualified technician.
SCHWAIGER can not be held responsible for damage or injury caused by improper installation or
improper use.
Note: The included mounting hardware is only suitable for solid wall/ceiling construction. If you are
not sure of the condition of the existing wall/ceiling in mind, consult a specialist. The included hard-
ware is not suitable for steel.