Schwaiger LWH 031, Инструкция по эксплуатации, Страница: 11 / 16

11
1.2 Concrete/Brick Installation
Note
1/4”(8mm) anchor must be used for concrete instal-
lation. They can be purchased at your local hardware
store.
1. Place the wall plate against the wall with the hook
towards the bottom.
2 Level and mark with a pencil the two mounting points
found on the wall plate.
3. Next, drill two holes using an electric drill and 1/4”
masonry bit.
4. Insert the threshold anchors into the holes that were
drilled in the wall.
Note: If necessary, use a hammer to lightly tap each anchor into place so that they are flush
with the wall.
5. Once the anchors are in place, put the wall piece back over the concrete anchors.
6. Using a screw driver, attach the back plate by threading the two screws into the anchor which has
been recessed into the wall.
7. Make sure all screws are snug, but be careful not to over-tighten them.
2. Attaching the Arm to the LCD
1. Determine the mounting hardware that is to be used.
2. If your LCD has a flat back, use the M4x12 mm Head Screws (B).
Note: If your LCD has a recessed back, use
the longer M4x30mm Phillips Head Screws (C)
and 3/4” spacers (D).
3. After you have determined the ap-
propriate screws, use them
to attach the mounting plate to the back of your
LCD
4. Do not over-tighten the screws.