SCHUNK TCU-Z, Сборка и руководство по эксплуатации

Страница: 22 / 28

Maintenance
22
02.00 | TCU-Z | Assembly and operating manual | en | 389464
6.4.2 Variant without locking (OV)
Position of the item numbers Assembly drawing [
}
23]
WARNING
Risk of injury due to unexpected movements!
If the power supply is switched on or residual energy remains in
the system, components can move unexpectedly and cause
serious injuries.
•
Before starting any work on the product: Switch off the power
supply and secure against restarting.
•
Make sure, that no residual energy remains in the system.
Ø
Disconnect cable connections.
Ø
Remove compressed air lines.
Ø
Remove product from handling device.
Ø
Remove screws (51) and separate product form the adapter
plate.
Ø
Remove screws (52) from the housing-top (02).
Ø
Remove screws (53) then remove bolt (09).
Ø
Separate housing top (22) from the flange bottom (01).
6.5 Servicing and assembling the product
Position of the item numbers Assembly drawing [ } 23]
WARNING
Risk of injury due to spring forces!
The cover is under spring tension.
•
Carefully disassemble the product.
Maintenance
• Remove screws (52) from the flange-bottom (01) and replace
shear-pads (15).
• Clean all parts thoroughly and check for damage and wear.
• Treat all greased areas with lubricant.
Lubricants/Lubrication points (basic lubrication) [ } 21]
• Oil or grease bare external steel parts.
• Replace all wear parts / seals.
– Position of the wearing parts Assembly drawing [ } 23]
– Seal kit Seal kit [
}
7]
Assembly Assembly takes place in the opposite order to disassembly