SCHUNK TCU-Z, Сборка и руководство по эксплуатации

Страница: 21 / 28

Maintenance
02.00 | TCU-Z | Assembly and operating manual | en | 389464
21
6.3 Lubricants/Lubrication points (basic lubrication)
SCHUNK recommends the lubricants listed.
During maintenance, treat all greased areas with lubricant. Thinly
apply lubricant with a lint-free cloth.
Lubricant point Lubricant
Metallic sliding surfaces microGLEIT GP 360
All seals Renolit HLT 2
Bore hole at the piston Renolit HLT 2
6.4 Disassemble the product
6.4.1 Variant with locking (MV)
Position of the item numbers Assembly drawing [ } 23]
WARNING
Risk of injury due to unexpected movements!
If the power supply is switched on or residual energy remains in
the system, components can move unexpectedly and cause
serious injuries.
•
Before starting any work on the product: Switch off the power
supply and secure against restarting.
•
Make sure, that no residual energy remains in the system.
Ø
Disconnect cable connections.
Ø
Remove compressed air lines.
Ø
Remove product from handling device.
Ø
Remove screws (51) and separate product form the adapter
plate.
Ø
Remove screws (52) from the housing-top (02).
Ø
WARNING Danger of injury due to spring forces! The cylinder
piston is under spring tension.
Remove screws (53) then
remove bolt (09).
Ø
Separate housing top (02) from the flange bottom (01).
Ø
Unscrew screws (49) and remove cylinder cover (04).
Ø
Remove cylinder piston (03) from the housing-top (02)