SCHUNK STM 560V Series, Сборка и руководство по эксплуатации

Страница: 17 / 72

Description of the module
04/STM-560V/en/2010-12-10/SW 17
5.1.2 Mechanical interfaces
The STM is mounted on a single Franke bearing. This bearing is
lubricated via one-time grease lubrication. Under normal
operating conditions lubrication for 20.000 operating hours is
sufficient (see Maintenance in chapter 11 page 63).
The mechanical interfaces are shown on the drawing in
chapter 13 page 67.
5.1.3 Electrical interface
Figure 2 STM schematic diagram
An incremental encoder (TTL signals) is installed as position
feedback unit.
In order to protect against impermissible operating conditions, the
temperature sensor can be used to control the temperature in the
windings. This data can be evaluated by the converter.
Maintenance-free
lubrication
U
V
W
Winding
Encoder
system
8
PE
2
Temperature sensor KTY84
STM basic carrier
UVW + PE E Temp.
Controller
Encoder
Encoder
values
Supply
voltage
STM plug connection