SCHUNK ROTA THWvario, Сборка и руководство по эксплуатации

Страница: 39 / 77

Assembly
01.00|ROTA THW vario |en-US 39
The attachment between power chuck and lathe must be prepared
for the use by the vario F. A suitable bayonet adapter with the
corresponding flange must be used between the power chuck and
the machine. For this, see the operating manual of the ROTA THW
vario 215-62.
1 Remove chuck jaw (item 2) from the chuck and insert
protective jaws (item 82) up to the max. position (marking on
chuck face).
NOTE
The mechanical system of the chuck is opened when the center
sleeve or the vario component are changed. No chips may
penetrate into the mechanical system of the chuck.
2 Remove center sleeve (item 4). To do this, remove the screws
(item 43) and screw them into the adjacent threads to press
the center sleeve off.
3 Clean the taper, the flat surface and the bayonet before
assembly.
4 Insert the vario component into the lathe chuck so that the
marking on the circumference of the vario is aligned with the
base jaw guide. The bayonets can be slid into each other in
this position.
5 Turn the vario approx. 60° until the screw threads are
positioned coaxially one above the other.