SCHUNK RCV, Сборка и руководство по эксплуатации

Страница: 33 / 44

Maintenance
8.4 Changing the cutter
WARNING
Risk of burns through contact with hot surfaces!
Surfaces of components can heat up severely during operation.
Skin contact with hot surfaces causes severe burns to the skin.
•
For all work in the vicinity of hot surfaces, wear safety gloves.
•
Before carrying out any work, make sure that all surfaces have
cooled down to the ambient temperature.
NOTE
Information on the wrenches is contained in the chapter
Scope of delivery [
}
6].
1. Remove the compressed air hose.
2.
When replacing with the same model : Measure and note the
length of the cutter beyond the clamping nut (2).
3. Use the smaller wrench from the accessory kit (4) to hold the
collet chuck.
4. The larger wrench from the accessory kit (3) can be used to
loosen the clamping nut anti-clockwise.
5. Pull the damaged cutter (1) out of the collet chuck.
6.
When replacing with the same model : Measure the exposed
part of the new cutter (1) with the data from step 2 and slide it
into the collet chuck nut (2) accordingly.
7. Use the smaller wrench (4) to hold the collet chuck.
8. Use the larger wrench (3) to tighten clamping nut clockwise.
33 02.00 | RCV | Assembly and Operating Manual | en | 1453513