SCHUNK RCV, Сборка и руководство по эксплуатации

Страница: 26 / 44

Assembly and settings
26 02.00 | RCV | Assembly and Operating Manual | en | 1453513
5.5 Start-up
CAUTION
Risk of damage to the product!
When deburring inner corners or inner radii, the product can be
damaged if the cutter touches two edges simultaneously.
•
During teach-in, make sure that the cutter never touches two
edges simultaneously.
•
The inner radius of a burr must never be less than 1.5 times
the diameter of the desired cutter.
•
After teach-in, increase the feed rate and ensure that the
cutter is deflected but remains in contact with the workpiece
surface.
Teach-in variant:
Dowel Teaching Tool
Cutter
Teaching
tool
Workpiece
Burr
Desired
contact point
with burr
Centering pin as
teaching tool
L
■
For the teach-in process, switch off the motor and apply
0.35 bar to the compensation air connection.
1. Insert a centering pin into the collet chuck instead of a cutter.
✓
The diameter of the centering pin corresponds to the shank
diameter of the desired cutter.
✓
Adjust the edge of the centering pin flush with the burr on
the workpiece.
✓
The diameter of the cutter is only so much larger than that
of the centering pin so that the compensation of the
product can compensate for this difference.
2. Teach-in traverse paths.