SCHUNK MV 15, Сборка и руководство по эксплуатации, Страница: 13 / 20

Assembly and installation
01.03|MV 15 - 30|en 13
Micro valve
NOTE
Always install the micro valves in the following sequence, for
example to avoid unscrewing the screw cap from the valve
cartridge if an accessory is fitted subsequently.
1 Screw the hollow screw of the swivel fitting (1) lightly into the
pneumatic unit (7), without tightening .
2 Turn the swivel fitting (1) to the desired position and hold it
firmly.
3 Tighten the hollow screw of the swivel fitting (1) in this positi-
on
Maximum torque, see Swivel fitting tightening torque table.
4 Screw the valve cartridge (2) into the swivel fitting (1) as far as
possible
Maximum torque 3 Nm .
5 Screw the accessory (5) into the valve cover (3)
Maximum torque 3 Nm .
6 Put the valve cover (3) on the cartridge (2) with the connecti-
on cable (4) in the required position.
7 Push the valve cover (5) onto the cartridge (2) and screw tight
with the knurled nut onto the cartridge (2)
Maximum torque 3 Nm .
8 Connect the pneumatic hose to the pneumatic connection (6)
of the swivel fitting (1).
9 Connect the micro valve to the electrical power supply,
(

6.2, Page 11) .