SCHUNK IndraDrive CS Series, Инструкции по вводу в эксплуатацию

Страница: 45 / 64

Commissioning
01.00|IndraDrive CS |en 43
Loading the motor parameters
NOTE
The work in this chapter is only necessary if no data has been pre-
installed in the control unit.
Set the control unit to Sercos III communication. This is done using
the front side panel.
Fig. 8 front side panel
1 Press the [Enter] button four times. The desired field bus vari-
ant will flash on the display.
2 Now use the cursor keys to select Sercos III.
3 Confirm your selection with the [Enter] button.

Sercos III will now be shown in the display and will no longer
flash.
4 Switch off the 24 V supply and then switch it back on again.

The control unit will reboot and Sercos III will be activated.
To verify: After starting up the display should show P -1.
5 Start IndraWorks DS on the PC.
3.2.1