6
K. ASSEMBLY INSTRUCTIONS
It is important to fully assemble your charger before use. Follow
these instructions for easy assembly.
PARTS
TOOLS NEEDED
Two, 0-32 thread cutting
screws
3/8" wrench (for mounting
foot)
Two, /4-20 thread cutting
screws
5/16" wrench (for wheels)
Two wheels
Hammer
One axle
Screwdriver (for handle
assembly)
Two axle caps
Two axle brackets
One handle
One handle clamp rod
One handle grip
One mounting foot
Attach Foot:
Remove charger from packing materials and place charger face
down. Attach mounting foot and secure with the two, /4-20 thread
cutting screws provided.
Axle Assembly:
Place the charger on its side. Place one end of each bracket into
slot, then place the axle assembly under each bracket. Fasten
the other side of each bracket using the two, 0-32 thread cutting
screws provided.
L. MAINTENANCE AND CARE
A minimal amount of care can keep your battery charger working
properly for years.
1. Clean the clamps each time you are finished charging. Wipe
off any battery fluid that may have come in contact with the
clamps to prevent corrosion.
2. Coil the input and output cords neatly when storing the charger.
The cords can be wrapped around the handle of the charger.
This will help prevent accidental damage to the cords and
charger.
3. Occasional cleaning of the case of the charger with a soft cloth
will keep the finish shiny and help prevent corrosion.
Axle Assembly:
Hold axle upright on floor or work surface. Then, using a hammer,
tap one of the axle caps onto the top end of the axle. Be sure to tap
the hub on straight. Slide both wheels onto the axle with the hubs
facing inward. Tap the other axle cap onto the opposite end of the
axle and place the axle assembly onto the bottom of the charger.
Handle:
Turn the charger right side up onto its foot and wheels. Verify grip
and handle clamp rod are installed on the handle. Remove the two
top screws from each side of the charger. Align the handle so the
screw holes are aligned with the screw holes on each side of the
wheel charger. Attach handle using the same screws.
BATTERY SIZE/RATING
CHARGE RATE/CHARGING
TIME - HOURS
2 AMP
20 AMP
40 AMP
SMALL
BATTERIES
Motorcycle, Garden
Tractor, etc.
6 - 2 AH
2 - 4
NR
NR
2 - 32 AH
4 - 0
NR
NR
CAR/TRUCKS
200 - 35 CCA
40 - 60 RC
- 4
90-20 min. 30-40 min.
35 - 550 CCA
60 - 85 RC
4 - 8
20-50 min. 40-45 min.
550 - 875 CCA
85 - 25 RC
8 - 35
2.5 - 4.5 hrs. 45-90 min.
MARINE/
DEEP CYCLE
80 RC
8
30 min.
NR
40 RC
27
3.5
NR
60 RC
30
4.0
NR
80 RC
33
4.5
NR