Schulze Big-O-Lite pneu plus, Инструкция по эксплуатации

Страница: 14 / 18

4.7 Replacing the silicon mat
To exchange the silicon mat the press must be disconnected from the electricity and cold. For the exchange you need a new silicon mat,
silicon glue, acetone and a notched trowel.
1. Remove the silicon mat with a knife restless.
2. Put an equal film of silicon glue on the plate using the notched trowel.
3. Put on the new silicon mat.
4. Close the pressure lever to press the silicon mat and the plate together.
5. Open the pressure lever and make sure that the plate and the mat lays exactly over each other.
6. Let the glue dry for 24hours.
7. Take of the heating plate and cut off the overlaying edge of the silicon mat.
4.8 Replacing the thermal fuse
The replacing may only be done by an authorized person.
For the replacement of the thermal fuse, the heat press
must be disconnected from the electricity and cold . Remove the cap from the
heating plate and remove the heat isolation (photo 1) . Then remove the thermal fuse (photo 2) and connect a new one (photo 3) .
Tighten it on the heating plate, put in the heat isolation and tighten the cap again. If you have the heating plate 400 x 500 mm the same
should be done with the second thermal fuse
(photo 4).
Version 16.01 14 / 18