Schulte Titan 5000 II Series, Руководство оператора, Страница: 100 / 108

MAINTENANCE
Titan 5000 Series II 01/22 Maintenance Section 5-4
© 2022 Alamo Group Inc.
MAINTENANCE
16. Install the piston (19) into the endcover (21). The two alignment pins in the piston (19) should be inserted
into the two holes in the bottom of the endcover (21).
17. Install the commutator (18) into the endcover (21) with the I.D. splines facing up. The commutator must be
timed correctly. There are two notches on the O.D. of the commutator (18). One of the notches is aligned
with a pin closer to the I.D. of the commutator. This notch is to be aligned with the small, drilled hole on the
I.D. land of the endcover (21). See Figures 1 and 2 for timing the commutator correctly.
18. Install the manifold dowel pin (17) into the endcover. Install the manifold (16) into the endcover with the
large openings facing up and the slot on the O.D. aligned with the dowel pin (17).
19. Install a 11/64 x 2 ½" pin (or similar) into the drain port of the endcover (21) and into the manifold (16)
(Note: If the pin is not used, the internal components of the endcover will fall out). The endcover contents
may need to be compressed to be able to insert the pin (or similar) through the drain port and into the
manifold.
20. Install the driver (15) into the rotor set (14). Place the endcover (21) onto the rotor set (14) aligning the
driver (15) into the commutator (18). (Caution: Make sure to visually align bolt holes before the driver is in
the commutator. If the commutator spins during installation, the motor will run in the reverse direction.)
21. Install nine assembly bolts (22) into endcover and pre-torque to 13,6 Nm [10 ft. lb.]. Final torque all bolts to
69,8 ± 7,5 Nm [51.5 ± 5.5 ft. lb.].
NOTE: See Parts Manual for corresponding part numbers.