Schulte SBX-75/87, Руководство оператора

Страница: 58 / 104

OPERATION
SBX-75/87 04/19 Operation Section 4-18
© 2019 Alamo Group Inc.
OPERA
T
ION
Hydraulic Cylinder Priming
Hydraulic Cylinder must be filled with hydraulic oil before operating. Hydraulic cylinders and lines are filled by
holding the valve control levers in the extended position until the cylinder fully retracts and extends. Place
control levers in the float position and repeat process several more times to purge all air from the system.
10.3 Connecting the Snow Blower and Skid Steer Hydraulic Lines
1. Before connecting the snow blower hydraulic
lines to the skid steer auxiliary hydraulic ports,
be sure that the hydraulic output capacity of the
skid steer matches the rated capacity of the
snow blower and that the hydraulic lines and
quick couplers are of the same size and type.
2. With the skid steer completely shut down and
secured in position and the snow blower resting
at ground level, relieve auxiliary hydraulic
pressure by moving the control levers back and
forth several times.
3. When connecting the skid steer hydraulic lines
to the snow blower, keep hoses, quick
couplers, and swivels free of contamination.
Clean dirt and other debris from the
connections with a clean rag to prevent
contamination of the hydraulic oil.
4. The snow blower will only operate with oil fed through the snow blower in one direction. If the snow blower
does not operate when the auxiliary hydraulics are engaged, oil is probably being fed through the motor in
the reverse direction. To correct this problem, reverse the hydraulic line connection between the snow
blower and skid steer and engage the hydraulics again or try engaging the auxiliary hydraulic lever in the
opposite direction.
5. Once hydraulic lines are properly connected for operation, secure cordura sleeving over couplers to retain
possible leaks.
NOTE: If hydraulic lines are removed from the pump or if couplers are removed from hose ends, ensure lines
and couplers are replaced in the same configuration as removed to ensure correct oil flow direction is
maintained.
11. PRE-OPERATION INSPECTION AND SERVICE
Before each use, a pre-operation inspection and service of the snow blower and tractor must be performed.
This includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped
Do not operate this Equipment with hydraulic oil or fuel leaking. Oil
and fuel are explosive and their presence could present a hazard. Do
not check for leaks with your hand! High-pressure oil streams from
breaks in the line could penetrate the skin and cause tissue damage
including gangrene. To check for a hose leak, SHUT the unit ENGINE
OFF and remove all hydraulic pressure. Wear oil impenetrable gloves,
safety glasses and use cardboard to check for evidence of oil leaks. If
you suspect a leak, REMOVE the HOSE and have it tested at a Dealer.
If oil does penetrate the skin, have the injury treated immediately by a
physician knowledgeable and skilled in this procedure.
(SG-15)