SCHOLTES Hotte, Инструкция по эксплуатации/Инструкция по безопасности

Страница: 28 / 36

28
2. INSTALLATION
2.1 Electrical connection
This equipment must be connected to a grounding plant. Two types of electrical
connection can be used:
1. Using a standard plug to be connected to the power cable and inserted in a mains
socket which must be accessible (so that the plug can be disconnected when servicing
is carried out). Make sure that the plug is accessible also after the complete installation
of the equipment.
2. By means of a fixed mains connection, fitting a bipolar switch, which ensures
the disconnection, with an opening distance of the contacts allowing a complete
disconnection on the conditions of the overvoltage III category, according to installation
regulations. The ground connection (yellow-green wire) must not be interrupted.
Refer to the rating plate inside the hood for the mains voltage and frequency ratings.
If the power cable is damaged, it must be replaced by the manufacturer or by its service
agent or a qualified person in order to avoid any risk.
2.2 Filtration modes
This cooker hood can be employed as evacuation or recycling.
Evacuation (Fig.5) :
Kitchen smokes are driven outside through a flue joined to the
exhaust pipe flue connector. This pipe must not under any circumstances be connected to
cooker, boiler or burner exhaust pipes, etc.
Recycling (Fig.6):
Smokes pass through the activated charcoal filter to be cleaned and
recycled in the kitchen environment by means of holes from which the purified air will come
out. These holes must be free and communicating with the kitchen environment.
Charcoal filters should not be implemented when using evacuation installation.
2.3 Installation
Read the instruction manual before installing and/or using the hood.
The unit must be fitted at a distance of at least 65 cm from the cooking hob. If the
mounting instructions of the gas cooker indicate a wider distance, respect it. Respect all
the air discharge regulations.
The air must not be discharged in a pipe used to discharge exhaust fumes produced by
gas-fed equipment or fuel-fed equipment (this does not apply to filtering hoods).
Installation A
1. Assembly pattern (Fig.7)
Paste the installing template provided within the product on the surface where the product is to
be installes. Make holes with 4mm diameter on the points marked as A, B, C, D on the installing
template. Drill the flue outlet hole specified in the installing template provided in the sizes given.