SCHNIER 810353, Руководство по эксплуатации

Страница: 31 / 36

Operating manual 810353-BALDE-150220 Version 20.02.2015 Page 31 of 36
Byte Bit Status bit Explanations
4 dI/dt switch off 1: Change of the output current larger
than the threshold value in the object
directory. A single malfunction.
0: If this malfunction does not occur
or is acknowledged.
The specified error is set so that this
switch off is deactivated. Because
this switch off disturbs the electrical
arc detection function.
5 Switch off after electrical arcs/t 1: Number of electrical arcs within tü
equals or is larger than the limit value
I in the object directory.
0: If this malfunction does not occur
or is acknowledged.
6 Switch off over-temperature of the
cascade 1: Temperature of the cascade above
65 °C.
0: If this malfunction does not occur
or is acknowledged.
7 Switch off over-temperature of the
power module 1: Temperature of the power module
above 75 °C.
0: If this malfunction does not occur
or is acknowledged.
3 0 Invalid parameter 1: Some parameter in the object di-
rectly set with invalid value.
0: If this malfunction does not occur
or is acknowledged.
1 Error 400V supply voltage. 1: 400V supply voltage is missing or
the communication between the
power module and control module is
interrupted.
0: If this malfunction does not occur
or is acknowledged.
2 Safety error 1: Plausibility check of the safety re-
lay failed.
0: If this malfunction does not occur
or is acknowledged.
3 Self test error 1: If the output voltage does not
reach 3 kV within 200 ms then the
HV generator has failed the self test.
0: If this malfunction does not occur
or is acknowledged.