II/ 8
SSP
GB
L
• Protect yourself and other persons, ani-
mals, property, and the environment by
taking the necessary protective measures
and being trained in use of the devices to
prevent harm to your health, property
damage, financial loss, environmental
harm or risk of accident.
• Be calm and focused and ensure proper
operation.
• Repairs may be carried out only by
Schneider Druckluft GmbH or its approved
service partners.
•
Prohibited:
manipulation, inappropriate
use, temporary repairs, use of other ener-
gy sources, removal or use of damaged
safety equipment, operating a leaking or
malfunctioning system, use of non-original
spare parts, exceeding the permitted
working pressure specified (max. + 10%),
working without protective equipment,
transporting / maintaining / repairing or
leaving a pressurised machine unattended,
using other / unsuitable lubricants, smok-
ing, naked flames, removing stickers.
•
Prohibited:
Using explosive or flammable
cleaning agents; disposing of leftover ma-
terials / cleaning agents incorrectly.
•
Prohibited:
Use in medical / food indus-
try; incorrect processing equipment; spark
formation.
2.4 Commissioning
Before start-up:
1. Observe technical data, figures, item
numbers, intended use and safety in-
structions
(see Instruction manual, Part 1, Chap-
ter: "Technical data" and the "Intended
use" chapter).
2. Carry out a visual inspection.
3. Do not use below 5° C.
L
Always use dry blasting abrasive with an
acceptable grain size such as ground blast
furnace slag.
L
Caution: the ventilation hole on the vessel
must remain open at all times.
In line with the device type:
Spray guns can be operated with a
blasting abrasive vessel or suction
hose:
1. Turn the blasting abrasive vessel
(item 05) anticlockwise (bayonet cou-
pling) to detach (Fig. 2a).
Blasting with blasting abrasive vessel:
2. Fill with blasting abrasive. Ventilation
point (item 15) must be open (Fig. 2b).
3. Attach blasting abrasive vessel and turn
clockwise to secure.
4. Attach nozzle (item 11), screw on up to
the stop and then unscrew 2 to 3 turns.
(Fig. 3a).
5. Secure the nozzle (item 11) using the
counternut (item 06).
6. Screw on the counternut up to the stop.
(Fig. 3a).
WARNING
Electrostatic charge possible!
X
Use antistatic air hose!
X
Earth the air hose!
CAUTION
Dangerous obstacle!
Air hoses laid on the ground.
X
Avoid or pay close attention.
NOTICE
Ensure proper ventilation:
X
Make sure the room is always well venti-
lated!
X
Wear eye and breathing protection!
NOTICE
Avoid damage and blockages in the air
nozzle:
X
Always set down spray guns containing
blasting abrasive in a vertical position!
