II/ 10
SSP
GB
2.9 Troubleshooting
Observe the safety instructions and maintenance instructions!
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
**See Chapter: "Intended use" in Instruction manual part 1!
***For troubleshooting: read chapter: "Commissioning"!
****For troubleshooting: read chapter: "Maintenance"!
If necessary, contact our service staff, see last page.
Problem
Cause
Remedy
A No material or
insufficient mate-
rial sprayed
Nozzle (item 11) blocked
X
Clean nozzle dry or replace
Nozzle (item 11) not adjusted
or setting incorrect
X
Adjust nozzle
***
Nozzle (item 11) or Venturi
nozzle worn
X
Replace nozzles or contact
Schneider Druckluft GmbH or
your local service partner.
Ventilation (item 15) on blast-
ing abrasive vessel blocked
X
Clean ventilation dry or replace
cover
****
Air pipe (item 07) on material
suction hose blocked
X
Clean air pipe dry or replace
Moist air
X
Install a water separator or com-
pressed air dryer
Blasting abrasive too coarse
X
Use blasting abrasive with a
maximum grain size of 0.8 mm
*
Hose diameter too small
X
Use correct hose diameter
*
Compressor output too small
X
Use different output
rating
*
Working pressure (flow pres-
sure) too low
X
Increase working pressure (flow
pressure) Observe maximum
working pressure
*
