GB
2.6 ELECTRICAL CONNECTIONS
Qualified personnel should carry out connecting unit to the main power. Be sure to check the local
codes in your area.
Before connecting the unit to the electrical supply, verify the data nameplate for the proper electrical information.
Voltage tolerance is +/- 5%.
Dryers are supplied with a junction box.
The dryers come with a mains connecting cable already installed and ending with a VDE 16A - Shucko plug.
Be sure to provide the proper fuses or breakers based on the data information located on the nameplate.
The mains socket must be provided with a
mains magneto-thermal differential breaker
(I
Δ
n=0.03A),
adjusted on the basis of the consumption of the dryer (see the nominal values on the data plate of the
dryer). The cross section of the power supply cables must comply with the consumption of the dryer, while
keeping into account also the ambient temperature, the conditions of the mains installation, the length of the
cables, and the requirements enforced by the local Power Provider.
Connect to a properly grounded outlet. Improper connection of the equipment-grounding conductor
can result in risk of electric shock. Do not use adapters on the main socket- if it does not fit the
outlet, have a proper outlet installed by a qualified electrician.
2.7 CONDENSATE DRAIN
The condensate is discharged at the system pressure.
Drain line should be secured.
Never point the condensate drain jet towards anybody.
The dryer comes already fitted with tubing in flexible plastics for the connection to the collection plant.
The condensate drain occurs through a solenoid valve protected with a mechanical strainer; the condensate
coming from the separator is previously filtered, then discharged.
The solenoid valve coil is operated by electronic instrument.
The dryer comes already fitted with an electronically level controlled condensate drain.
Connect and properly fasten the condensate drain to a collecting plant or container.
The drainers cannot be connected to pressurized systems.
Don’t dispose the condensate in the environment.
The condensate collected in the dryer contains oil particles released in the air by the compressor.
Dispose the condensate in compliance with the local rules.
We suggest to install a water-oil separator where to convey all the condensate drain coming from
compressors, dryers, tanks, filters, etc.
3.1 PRELIMINARY OPERATION
Verify that the operating parameters match with the nominal values reported on the data plate of
the dryer (voltage, frequency, air pressure, air temperature, ambient temperature, etc.).
This dryer has been thoroughly tested, packaged and inspected prior to shipment. Nevertheless, the unit
could be damaged during transportation, check the integrity of the dryer during first start-up and monitor
operation during the first hours of operation.
Qualified personnel must perform the first start-up.
When installing and operating this equipment, comply with all National Electrical Code and any
applicable federal, state and local codes.
Who is operating the unit is responsible for the proper and safe operation of the dryer.
Do not operate equipment with panels (or pressure parts or electric parts covers) removed or
tampered
Содержание DK 2300
Страница 36: ...7 1 1 DK 2300 DK 3000...
Страница 37: ...7 1 2 DK 2300 DK 3000...
