Table-top
Operating table OPX mobilis and OPX mobilis RC –
E
DITION
05-03-GB
ID.-Nr.: 02008857
29
Table-top
Folding the back section on top of the seat section
The back section of the table has to be folded on top of
the seat section in order to carry out repairs at the upper
part of the height adjustment column. In order to do so,
loosen first the bolt fastenings of the gas springs - in the
mobilis RC 40: the relative hydraulic cylinder for back
section adjustment - at the seat section frame.
•
In order to fold the back section on top of the seat
section, remove the head plate and the pads for the
back section and for the seat section.
a
Attention!
When the gas springs have been removed, the
back section may fall down and thus damage
the follower screw of the safety sheet between
the seat and back sections. Screw the follower
screw out.
•
Screw the follower screws (M3) at the left and right
hand side of the safety plate between the seat section
and the back section out.
•
Loosen the threaded bolts in front of the bearing bolts
at the inner side of the seat section frame. Drive the
right hand and left hand bearing bolts out using a drift
bolt.
•
Fold the back section on top of the seat section and
carry out the repairs.
•
As soon as the repairs have been carried out, fasten
the gas springs and/or the hydraulic cylinders in
reverse order to the seat section frame.
Back section pad
Seat section pad
Follower screw
