Schmalz FXP-S-SVK SPB2, Руководство по эксплуатации

Страница: 25 / 28

Bedienungsanleitung FXP(-S)-SVK / FXP(-S)-SW
Operating Instructions FXP(-S)-SVK / FXP(-S)-SW
30.30.01.01016
Status 10.2017 / Index 2
J. Schmalz GmbH
Johannes-Schmalz-Str. 1
D - 72293 Glatten
Tel +49 (0) 7443 / 2403 - 0
Fax +49 (0) 7443 / 2403 - 259
www.schmalz.com
schmalz@schmalz.de
Page -23-
Interval
Daily Weekly Monthly Every six
months
Annual
check
Check all load-bearing parts (e.g. suspension) for deformation, wear or
other damage
X X
Check the sealing plates or suction
pads for wear, cracks and leaks;
replace if necessary
X X
Check whether the optional filter fleece is dirty X X
Check whether the optional suction pad filter plate is dirty X X
General condition of the device X
Leak test
When the ejector is switched on and the smooth, non-permeable
surface of a workpiece (e.g. a metal plate) is fully picked up, the system
vacuum at the vacuum gauge (see Section 3, Item 5) must indicate a
vacuum that is no more than 20% lower than the maximum possible
vacuum of the ejector used. Example: Ejector reaches max. -0.55 bar.
A vacuum between -0.45 and -0.55 bar must be shown on the gauge.
X X
Vacuum test
When the ejector is switched on and no workpiece is picked up, the
system vacuum at the vacuum gauge must indicate a vacuum between
-0.20 and -0.4 bar. For the large-area gripper FMP with SVK valve
technology, between -0.35 and -0.5 bar
X X
Visual inspection of the check valves and flow resistors to see whether
they are contaminated
X X
Has the dust filter been cleaned? (Fig. 4.3) X X
Are the compressed air hoses in good condition (not brittle, not kinked,
no worn sections and no leaks)?
X X
Is the type plate still on the device? X
Are the operating instructions still available and are workers familiar
with them?
X
Clean the sealing plate with a soft brush and a vacuum cleaner, and
remove wood chips, dust, etc. Do not blow off with compressed air.
The force of the stream of compressed air would destroy the structure
of the foam
X
Check and adjust connections, screws, etc. X
Check hose lines and connections for leakage X
Note: Suspension, compressed air hoses and pressure filters are not part of the FXP device.
video
www.schmalz.com/
sealing-foam-replacement