Schmalz 10.01.38.06676, Краткое руководство пользователя

Страница: 14 / 18

5 / EN EN· 30.30.01.02952 · 00 · 07/21
3.2 Functions in the Main Menu
The following table shows an overview of the display codes and parameters in the main menu:
Display
code
Parameter Explanation
Switching point 1 Value at which the control function deactivates
(Only active when )
Reset point 1 Reset value 1 for the control function
Switching point 2 Switching value for the “Parts control” signal
Reset point 2 Reset value 2 for the “Parts control” signal
Blow off time Setting of the blow off time for time-controlled blow off
Zero-point adjustment
(calibration) Calibrate vacuum sensor, zero point = ambient pressure
Extended functions Open the “Extended Functions” submenu
Information Open the “Information” submenu
Incorrect The entered value is not within the permissible value range.
This is an informational message that appears if incorrect information is
entered.
3.2.1 Changing the Parameters of the Main menu
If you wish to change values, e.g. the switching points, you have to enter the new value digit by digit.
1. Use the button to select the desired parameter.
2. Confirm using the button.

The currently set value is displayed and the first digit flashes.
3. Use the button to change the value. The value increases by 1 each time the button is pressed. After 9, the
counter goes back to 0 when the button is pressed.
4. Press the button to save the modified value.

The first digit is accepted and the second digit flashes.
5. Use the button to select the second digit.
6. Press the button to save the modified value.

The second digit is accepted and the third digit flashes.
7. Use the button to select the third digit.
8. Press the button to save the modified value.

If the value entered lies within the permissible value range, it is accepted and the modified parameter is
displayed.

If the value entered is not within the permitted value range, this is indicated briefly by the display [ ]
and the new value is not applied.
If input is interrupted for longer than 1 minute or if no input is made, the display automatically switches to the
measurement display.