Schlage WRI400, Инструкция по эксплуатации

Страница: 20 / 24

20 • Schlage • WRI400 user guide
Troubleshooting
Problem
Problem
indication Solution
WRI400 is not
operating
No blink from
PWR/TAMPER
LED
Confirm connection to external power supply. See
Wiring the WRI400 to access control peripherals on
page 10.
The PWR/TAMPER LED should flash green when the
WRI400 is powered and the cover is removed.
WRI400 to
PIM400 linking
is unsuccessful
Four RED blinks at
the end of a LINK
attempt
No data is getting
to the ACP
No data is getting
to the PIM –
diagnostics do not
show DOOR status
Check the distance between the WRI400 and the
PIM400. Maximum distance is 200 feet (61 meters).
The WRI400 and the PIM400 must be located on the
same floor of the building.
Make sure the PIM400 is in link mode before
attempting to link to the WRI400. See Link the
WRI400 to a PIM400
on page 18.
A remote antenna module connected to the WRI400
and/or the PIM400 will improve RF communication.
See
PIM400 and WRI400 location
on page 5.
NOTE: Two short red blinks from the RX/TX is normal
for an unauthorized card.
The credential
reader is not
operating
properly
The WRI400
STRIKE Relay/LED
is not activated
when a card or
keypad credential
is presented
Confirm that the four connections required for basic
operation readers are properly connected: Power,
Ground, CLK/D1 and DATA/D0.
Confirm that CLK/D1 and DATA/D0 wiring is not
reversed.
Consult the reader’s user guide and confirm that the
reader has specified power.
The reader’s
beeper and/or LED
is not functioning
as expected
The WRI400 may not control or configure the
reader’s beeper or LED settings.
Consult the reader’s user guide for more information
on configuring the reader’s beeper, or the reader’s
LED patterns.
HHD is not
communicating
with the
WRI400
No USB LED
HHD display
reads “No Device
Connected”
Make sure the USB connector is properly connected.
The USB LED will blink green.
Set the HHD connection type to “USB”.
See
Handheld device (HHD) on page 17.
Unable to
configure
settings with
HHD
HHD display reads
“Your HHD is not
authenticated to
perform this action”
Check that the HHD is properly coupled to the
WRI400.
See
Handheld device (HHD)
on page 17.