19 • Schlage • WRI400 user guide
Reset to factory defaults
All information in the WRI400 will be deleted and reset to factory defaults!
1. Remove the WRI400 cover.
The WRI400 will signal tamper to the access control panel while the cover is off.
2. Press and hold both the Schlage and link buttons for three (3) seconds.
3. Upon completion of factory default reset the WRI400 debug LED will blink green
for one second, and the WRI400 will signal the reader’s LED to blink green for one
second and the beeper to sound.
4. Replace the cover.
Test
Test the WRI400 with power applied
1. The lid tamper LED will blink green when the WRI400 cover is removed and will light
solid green when the lid tamper switch is pressed.
2. Most readers are designed to function independently of the WRI400. If the reader’s LED
and beeper performance is irregular or unexpected, refer to the instructions that came
with the reader.
Schlage button test
L
Performing the Schlage Button Test will not result in the loss of any WRI400
settings or programming changes.
1. While holding the Schlage button, press and release the reset button.
2. All relays, on-board LEDs, reader LEDs and reader beeper will be active while the
Schlage button is pressed.
WRI400 in construction mode
1. After programming a Construction Credential (refer to page 18), present a valid
Construction Credential to the reader.
2. The WRI400 strike relay will activate for the length of the default relock delay. The aux
relay will not activate.
WRI400 linked to PIM400 and communicating with ACP
1. Present a valid credential to the reader.
2. The WRI400’s strike relay and strike LED will activate for the relock delay.
L
A valid credential will not activate the AUX relay unless the ACP has given the
credential authorization to do so.
3. If an invalid credential is presented to the reader, the WRI400’s RX/TX LED will blink
red twice.
L
The ACP may be capable of indicating the WRI400 status for the following:
-
Lid tamper
-
Request to enter
-
Request to exit
-
Door position switch
Default settings for the above inputs can be configured using the HHD and/or the ACP.
