3
WPR400 Wireless Portable Reader User Guide
OVERVIEW
The WPR400 is a Wireless Access Point Module (WAPM) designed to interface with access control
panels through a PIM400. The WPR400:
• Communicates with the PIM400 via RF (radio frequency).
• May be linked only to a PIM400.
• Is powered with rechargeable batteries.
• May be used with all credential readers in the AD-Series product line.
• When attached to a credential reader, normally operates in on-line (Reader) mode. Information
contained in the user credentials is passed to an access control panel (ACP), which controls
WPR400 LEDs. The ACP maintains the audit trail.
• May be operated in Test mode, with or without a credential reader. In Test mode, the WPR400
continually tests the quality of the RF link with a PIM400.
The WPR400 is shipped in “reader” mode. See Test Mode on page 10 for information on using
the WRP400 as a tester.
If ordered as WPR400 x DT, the unit is shipped in Test mode.
LED Indicators
Schlage Button
On / Off Switch
Power Jack
GETTING STARTED
Follow these steps when setting up a WPR400.
1. Install the PIM400. Refer to the User Guide that came with the PIM400, or visit www.schlage.
com/support, for more information.
2. Make sure PIM400 power is properly connected.
3. The WPR400 is shipped with batteries installed and ready for confi guration. If the batteries need
charging or replacing, please see
Batteries
on page 13. Make sure batteries are fully charged
before use.
4. Familiarize yourself with the information contained in this user guide.
!
Save this user guide for future reference.
